Editing Panasonic 3DO FZ-10 Teardown
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 41: | Line 41: | ||
==Step 5 - Recap== | ==Step 5 - Recap== | ||
− | [[File:3DO_FZ10_teardown_05.jpg|thumb|400px]]The next thing we're going to do is remove the CD drive, but first, as a brief recap, here is what your 3DO should look like if you remove the drive cover by pulling off the tape. If you want to keep the drive cover attached to the RF shield with the original tape, then skip ahead to step 7, remove the screws holding down the RF shield, remove | + | [[File:3DO_FZ10_teardown_05.jpg|thumb|400px]]The next thing we're going to do is remove the CD drive, but first, as a brief recap, here is what your 3DO should look like if you remove the drive cover by pulling off the tape. If you want to keep the drive cover attached to the RF shield with the original tape, then skip ahead to step 7, remove the screws holding down the RF shield, and remove the whole thing to get it out of your way. |
In total the drive is tethered to the board in 5 places, 4 of which are underneath the drive. For now, go ahead and remove the orange/brown set of cords and remove them from the plastic trench. If you have problems detaching the cord from the board, try tucking your fingernails underneath the small plastic edges to get a grip. | In total the drive is tethered to the board in 5 places, 4 of which are underneath the drive. For now, go ahead and remove the orange/brown set of cords and remove them from the plastic trench. If you have problems detaching the cord from the board, try tucking your fingernails underneath the small plastic edges to get a grip. |