988
edits
Changes
Jump to navigation
Jump to search
<i>This is a stub.</i>
no edit summary
This is a guide for completely dismantling a [[ColecoVision]] to gain access to the motherboard and to be able to clean the inside of the case. Opening the console is fairly straightforward with the only complication being removing the top of the case.
There are a few things to keep in mind when putting the [[ColecoVision]] back together. The first is that the top and bottom RF shields interlock above the expansion slot, so don't forget to make sure the tabs slide into place (see picture). Also, the position of the power cords matters since you don't want them to get pinched and prevent the case from being fully closed. And don't forget to put the power switch and reset button back on!
Now to what you were probably wondering about: reattaching the top of the case. It's easier than taking it off but can still be a bit tricky. I suggest first setting the back of the top into place and allowing the front to rest as seen in the picture.All you need to do then is pull the front panel forward at the corners so that it can fall past the plastic rim. When you do this, the front will appear to be in place, but the back will now be out of alignment. Use a hand to gently but firmly squeeze the top back into place, keeping in mind that what you're trying to do is force the front panel back into place, snugly attached to the plastic rim.<gallery widths="150" spacing="small">Colecovision-teardown09.jpg|Side view of how the front should rest on the rim when reattaching the topColecovision-teardown08.jpg</gallery> [[Category:Teardown]]
