Editing N64 Joystick Controller Replacement

This is a quick guide on replacing a faulty joystick on an [[Nintendo 64]] controller. This can also be considered a mod if you are upgrading the joystick to a [http://amzn.to/1gI9qXM redesigned replacement]. Upgrading is recommended because the Nintendo 64 has a poorly designed joystick that is prone to breaking and because the redesigned joystick has better control. 

Tools needed:
*Small phllips head screwdriver
*[http://amzn.to/1gI9qXM Replacement Joystick]

==Guide==

===Step 1===

Begin by removing the 7 #0 Phillips screws from the back of the controller grips as shown. Remove the 2 #00 Phillips screws from the expansion slot. Remove the rear housing and set aside.

===Step 2===

Gently remove the Z-Button membrane and board by sliding them to the left and pulling out of the joystick assembly. Remove the 3 #00 Phillips screws holding the joystick assembly in place.

===Step 3===
[[File:Nintendo_64_Controller_Guide2.jpg|thumb]]
Disconnect the joystick data cable and remove the old joystick. To install your new joystick, simply follow these instructions in reverse.

===Step 4===

Test out your controller! It should be feeling like new.